|
|
Item Posts
Sort Order
|
|
|
350 CYLINDER HEAD INTERCHANGE
|
riberware
I love my Chevy Chevette!
| Posts: 1
| Joined: 06/09
Posted: 06/14/09
05:16 PM
|
|
Last week I blow the block of my 1990 350 SBC installed on my Jeep...this engine came off a Camaro Irok-Z... I got a pre '80s block with the 2 piece rear main seal... is it possible to use my actual center bold cylinder heads with this old block???...
I want to install the center bolt heads, 87+intake manifold and 4 barrel carb on this block...
Thanks for the help.
-Ricky
|
|
|
|
chevelle83
I have an SS396 tatoo
| Posts: 356
| Joined: 10/08
Posted: 06/14/09
05:53 PM
|
|
yes, the block is the same every thing will bolt right up. The only difference is the back of the block at the rear main journal for the 1 piece seal adapter, the 87+ oil pan has to be used and the dipstick is on the passenger side. This block should be machined for a roller cam so you can throw in a roller cam if you want to. Just look behind the cam sprocket there will be 2 bolt holes for the cam thrust plate and holes down the center of the valley for the "spider" plate to hold the lifters steady.
|
|
|
|
Pontiacman2
Everything in my driveway’s a Chevy
| Posts: 647
| Joined: 01/08
Posted: 06/15/09
03:56 AM
|
|
Yes The center bolt heads will work on the older block.
Professional hi-performance engine builder
Horsepower sells Engines and torque wins races.
|
|
|
|
|
|
85_trans_am
My first time was in a Chevy
| Posts: 240
| Joined: 05/09
Posted: 06/15/09
04:27 PM
|
|
your not going to have any problems
|
|
|
|
|
|
|